Controls Two Pumps with Easy Pump Connections
The new and improved Ultra Nator™ control and alarm system controls two alternating 120V 1 HP or 15 Amp single phase pumps in duplex pump applications.
The plug and play design features a factory-installed 10' power cord, floats and pump receptacles (no field wiring required to quickly connect two sump pumps).
The new battery back-up alarm system maintains the alarm function if primary power is lost; you can quickly test the battery condition with the battery test function. The new pump failure indicator alerts you to potential pump problems, such as non-operating pumps, problems with outflow plumbing, or if the water inflow is greater than pumping capacity. The reference chart on the panel front helps the operator diagnose problems quickly.
In normal operation, the pump will alternate based on the pump switch level. If an alarm condition occurs (top float activates), the alarm light and horn turn on. The pump in use will turn off and the other pump will turn on. Pumping will continue until the pump switch deactivates (bottom float).
NOTE: The Ultra Nator™ will only run one pump at a time.
Three-Year Limited Warranty
6 x 6 x 4 inches (15.24 x 15.24 x 10.16 cm)
NEMA 1 rated thermoplastic
Primary: 120 VAC
Secondary: 9 VDC
OUTPUT CONTACT RATING:
120 VAC NEMA type 5-15
95 decibles at 2 feet (0.61 meters)
Adobe Acrobat is a free download to view .pdfs
Visit our downloads section of this website for additional literature.